Draper 65084 원본 사용 설명서 - 페이지 13

{카테고리_이름} Draper 65084에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 65084 20 페이지. Dual action air composite sander
Draper 65084에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

8. Maintenance and Storage

Important: ALWAYS ensure that the air supply is

disconnected from the tool before performing any

maintenance or storing the product.

8.1 General Maintenance

• Keep the air line inlet, exhaust and dust outlet free

from dust, debris and other obstructions.

• Regularly check the tightness of the backing plate

to ensure a firm fit that does not exhibit resistance

when rotated.

• Periodically check the sanding pads and backing

sheets for damage or wear and replace them

as necessary.

• Keep the hook and eye pad of the backing plate

free from debris to ensure a secure grip on the

sanding pad.

• Lubricate the mechanism by pouring a few drops

of air tool oil into the air line inlet before and after

every use.

• Ensure that the air line is sufficiently lubricated and

apply additional lubrication into the air line inlet if

evidence of binding occurs.

• Maintain the air line appropriately:

− Drain the compressor reservoir and air

lines of condensate and dispose of the

liquid appropriately.

− Drain the water trap.

− Drain and fill the combined separator filter,

regulator and lubricant reservoir.

− Ensure that the air line pressure is appropriate for

the tool.

8.2 Replacing the Backing Plate

The backing plate should be replaced if it becomes

damaged, can no longer be sufficiently fastened, or no

longer grips the sanding pads securely.

1. Lift the rubber shroud (7) slightly and locate the

spindle locking nut.

2. Insert the 24mm spanner (C) under the shroud and

locate it around the spindle locking nut.

(7)

(C)

Fig.

3. Use the spanner to hold the spindle locking nut in

place and rotate the backing plate (2) forwards as

indicated on the shroud.

(2)

Fig.

4. Install a new backing plate onto the spindle, using the

spanner to hold the locking nut in place and rotating

the plate in the reverse direction.

CAUTION! DO NOT overtighten the backing

plate as this may restrict the motion of

the plate.

Important: ALWAYS ensure that the spanner has been

removed before reconnecting the air line.

– 13 –