Draper 98427 사용 설명서 - 페이지 13

{카테고리_이름} Draper 98427에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 98427 20 페이지. 230v oscillating spindle sander

PREPARING THE SANDER

8.4

TABLE INSERTS - FIG.6

This sander comes supplied with 6 x table inserts.

With a selection of round and oval cutouts.

For normal sanding, select the inserts with the

round cutout.

Make note of the cutout on the edge of the table

insert. This aligns the peg into the recess of the

table (FIG.6). Lower into position, making sure that

the table insert locates into the recess and is flush

with the table.

To remove, push with your finger from underneath

to dislodge the table insert.

8.5

ENSURING THE TABLE TOP

ALIGNS WITH ZERO DEGREES

- FIGS.7 AND 8

The table top has the facility to tilt between 0° to

45°.

Note: Ensure that the table is set to 0° with

regards to the bobbin. Use a suitable 90° square

and place on the table top surface, then move the

square with the bobbin confirming that it measures

90°accurately (FIG. 7).

If the table is not square, adjustment can be made

to correct this. The stop bolt is located under the

table and this allows for the adjustment of the level

of the table.

Loosen the lock nut and raise or lower the stop

bolt. Note when the table is set at 90° along with

the bobbin then tighten the lock nut.

Locate the pointer and scale and untighten the

pointer screw. Align with the 0° position on the

scake and re-tighten the screw (FIG. 8)

FIG.

FIG.6

FIG.

FIG.7

FIG.6

FIG.8

FIG.

– 13 –