Draper 98427 사용 설명서 - 페이지 14

{카테고리_이름} Draper 98427에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 98427 20 페이지. 230v oscillating spindle sander

OPERATING THE SANDER

9.1

TILTING THE TABLE - FIG.9

Note: Remove the round cutout table insert before

tilting the table to avoid damaging the insert.

The table will tilt 0°-45°. Once the desired angle

has been set, tighten the two locking knobs found

underneath the table

Locate the oval table insert cutout

into the table top.

9.2

ON/OFF NO-VOLT SWITCH -

FIG.10

This sander has a On/off no volt switch with an

emergency stop function

power failure, the motor will not start when power

if restored.

Ensure that the sander is plugged into a suitable

13A outlet socket.

Lift the emergency stop cover to reveal the On/off

switch (Fig. 10).

To switch on, press the green button and the

sander will start. Then close the emergency stop

cover. Do not push the red button as this will cause

the motor to stop.

9.3

FIG.11

Simply press this button to stop the machine.

There is no need to lift the cover when activating

the emergency stop button. In the event of a power

failure, the machine will not restart when the power

is restored after pressing the emergency stop

button.

(FIG. 9).

and place

. In the event of a

FIG. 8

FIG.9

FIG.10

FIG.11

– 14 –