Draw tite 24963 설치 지침 - 페이지 4

{카테고리_이름} Draw tite 24963에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draw tite 24963 4 페이지. 2017 - current hyundai ioniq

3. Install hitch – Raise hitch into position, raising the passenger's side hitch bracket above the exhaust first, then raise the driver's side into position. Using the

supplied hardware, loosely install the M10 bolts and conical toothed washers as shown. See Figure 1. NOTE: It may be necessary to clean debris from existing

weldnuts in frame using a wire brush or compressed air.

4. Tighten all M10 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)

5. Trim underbody panel – using a tape measure, marker, and utility knife,

measure, mark, and trim the driver's side underbody panel. See Figure 2.

3-1/2"

5-1/2"

Figure 2

Proper torque is needed to keep the hitch secure to the vehicle when towing.

6. Reinstall underbody panel – reinstall the underbody panel using (5) push

pin rivets and (1) hex nut removed in step 1.

7. Raise muffler back into position and reattach all rubber hangers removed

in step 2.

On our website you can discover more about trailer hitches and towing.