Drawell DW-TDZ5-WS 운영 매뉴얼 - 페이지 3

{카테고리_이름} Drawell DW-TDZ5-WS에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Drawell DW-TDZ5-WS 20 페이지. Benchtop low-speed centrifuge

Safety Notices

We appreciate your business with us. To prevent any potential accident,

please operate centrifuges according to the following safety protocol.

Safety in installation and maintenance

* The electricity should be cut off before repairing. Please take care if

instrument must be repaired with electricity on. Before opening any lids, please

cut off the electricity and wait for 4 minutes.

* Make sure for placing centrifuge on a steady floor or table and adjusting the

level for normal operation.

* The power supply of centrifuge is the type of nameplate. If you have any

problem of the type of power, please consult the dealer and power supply

bureau in your place.

* As safety measures, the centrifuge equipped with a single-phase

three-phase cable, and the longer cable connects with casing as the protection

grounding. If your sockets hasn't protection grounding, please contact your

electrician to replace the original socket without allowing security role of

single-phase with three-wire power cable to be invalid.

* When replacing parts, the serviceman should use parts manufacturer

required with the same function of original parts. The unrecognized alternative

parts many cause fire, electric shock or other hazards.

* The room should be installed an air-conditioner for good refrigerating effect

when temperature is higher than 35.℃.

* Please keep cleaning of the installation site for the centrifuge. Pay attention

to the blockage of condenser, it should be cleaned once in three months for

guarantee the refrigerating effect.

* Don't unpack and repair instrument by oneself. Please contact with our

technicians for necessary matter.

Attention for fireproofing

* Small breaker (Air switch) can protect the circuit when centrifuge

over-currents. Please use breaker (air switch) with same specification and