Bosch WLK24261BY 사용 설명서 및 설치 지침 - 페이지 29

{카테고리_이름} Bosch WLK24261BY에 대한 사용 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WLK24261BY 42 페이지.

Faults
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle activated sev-
eral times.
The programme takes
longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the care
product dispenser.
Odours in the washing
machine.
N symbol flashes. Foam
may escape from the
detergent drawer.
Intense noise, vibrations
and "wandering" during
spinning.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
Detergent residue on the
laundry.
The colon on the Ready
in display : is flashing.
The single dot (.) flashes. Undervoltage during the washing programme causes an extending of the wash
Cause/Remedy
– – – (Rinse stop = without final spin cycle) selected? ~ Page 21
Clean the drain pump. ~ Page 26
Clean the outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed. Distribute small and large
items of washing in the drum.
Too low speed selected?
Not a fault – unbalanced load detection system adjusts imbalance.
Not a fault – unbalanced load detection system adjusts imbalance by
repeatedly distributing the laundry.
Not a fault – foam detection system active – a rinse cycle is switched on.
Not a fault – VoltCheck active ~ Page 24
Not a fault – the programme sequence is optimised for the particular wash pro-
cess. This may result in changes to the programme duration in the display field.
Not a fault – the effect of the care product is not affected.
Clean the insert if necessary.
Run the i ü Cottons 90 °C programme without laundry. Use standard
detergent for this.
Too much detergent used?
Mix one tablespoonful of fabric softener with 1/2 litre water and pour into com-
partment II (Not for outdoor fabrics, sportswear fabrics or those made with
down.)
Reduce detergent dosage for the next wash cycle.
Appliance aligned? Level the appliance. ~ Page 37
Appliance feet fixed? Secure appliance feet. ~ Page 37
Transportation protection devices removed? Remove transportation bolts.
~ Page 34
Power failure?
Fuse tripped? Switch on/replace the circuit breakers.
If the fault occurs repeatedly, call the after-sales service. ~ Page 30
Occasionally, phosphate-free detergents contain water-insoluble residue.
Select O Rinse or brush the laundry after washing.
Mains voltage too low ~ Page 24
programme. ~ Page 24
Faults and what to do about them.
en
29