Bosch WLK24261BY Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 29

Yıkayıcı Bosch WLK24261BY için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Bosch WLK24261BY 42 sayfaları.

Sayfayı Yazdır

Faults

Detergent solution is not

drained.

Water not visible in the

drum.

Spin result not satisfac-

tory.

Laundry wet/too damp.

Spin cycle activated sev-

eral times.

The programme takes

longer than usual.

The programme duration

changes during the wash

cycle.

Residual water in the care

product dispenser.

Odours in the washing

machine.

N symbol flashes. Foam

may escape from the

detergent drawer.

Intense noise, vibrations

and "wandering" during

spinning.

Display panel/indicator

lights do not function

while the appliance is run-

ning.

Detergent residue on the

laundry.

The colon on the Ready

in display : is flashing.

The single dot (.) flashes. Undervoltage during the washing programme causes an extending of the wash

Cause/Remedy

– – – (Rinse stop = without final spin cycle) selected? ~ Page 21

■

Clean the drain pump. ~ Page 26

■

Clean the outlet pipe and/or drainage hose.

■

Not a fault – water below the visible area.

Not a fault – the unbalanced load detection system has interrupted the spin

■

because the laundry is unevenly distributed. Distribute small and large

items of washing in the drum.

Too low speed selected?

■

Not a fault – unbalanced load detection system adjusts imbalance.

Not a fault – unbalanced load detection system adjusts imbalance by

■

repeatedly distributing the laundry.

Not a fault – foam detection system active – a rinse cycle is switched on.

■

Not a fault – VoltCheck active ~ Page 24

■

Not a fault – the programme sequence is optimised for the particular wash pro-

cess. This may result in changes to the programme duration in the display field.

Not a fault – the effect of the care product is not affected.

■

Clean the insert if necessary.

■

Run the i ü Cottons 90 °C programme without laundry. Use standard

detergent for this.

Too much detergent used?

Mix one tablespoonful of fabric softener with 1/2 litre water and pour into com-

partment II (Not for outdoor fabrics, sportswear fabrics or those made with

down.)

Reduce detergent dosage for the next wash cycle.

Appliance aligned? Level the appliance. ~ Page 37

■

Appliance feet fixed? Secure appliance feet. ~ Page 37

■

Transportation protection devices removed? Remove transportation bolts.

■

~ Page 34

Power failure?

■

Fuse tripped? Switch on/replace the circuit breakers.

■

If the fault occurs repeatedly, call the after-sales service. ~ Page 30

■

Occasionally, phosphate-free detergents contain water-insoluble residue.

■

Select O Rinse or brush the laundry after washing.

■

Mains voltage too low ~ Page 24

programme. ~ Page 24

Faults and what to do about them.