Drawmer SP2120 설치

{카테고리_이름} Drawmer SP2120에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Drawmer SP2120 1 페이지. Speaker protector
Drawmer SP2120에 대해서도 마찬가지입니다: 운영자 매뉴얼 (9 페이지)

페이지 인쇄

Drawmer have gone to great lengths to make the Speaker Protector tamper-proof by incorporating the locking mechanism on the front. However, if the rear of the unit, along with the

power amplifier, were reconnected, by an engineer/dj trying to gain more level, then the protection system would effectively be bypassed. For this reason Drawmer have designed the

Speaker Protector Tamper-proof Bracket - trapping the XLR's in place and making it extremely difficult to disconnect them without removing the bracket. This bracket could be specified

in order to conform to Local Authority noise abatement regulations.

SP2120

Speaker Protector Tamper-proof Bracket

INSTALLATION

Installation of the Tamper-proof bracket could not be simpler:

After setting up the SP2120 Speaker Protector as described in the manual,

with the XLR's in place, simply slide the Tamper-proof Bracket over the rear of

the unit, making sure that the protruding cables locate through the gaps on the

bracket. Next, screw in to place at the four locating points (arrowed) using the

M3 screws provided. Further protection can be gained by fitting M3 TORX

tamperproof screws, to a maximum length of 6mm, though a specialist

screwdriver will also be required.

In addition, for extra protection, both the SP2120 and the power amp should be

locked in a rack, where access to the rear is very difficult.

You should note that the Tamper-proof bracket is only available for SP2120's

who's serial number is 0845 or higher (September 2006). On older versions the

bracket could be retro- fitted, though this would invalidate any warranty that

Drawmer has provided for the SP2120. Alternatively, Drawmer could bring your

SP2120 up to current Drawmer specification - please contact your local distributor

or email: [email protected] for further details.