Drawmer SP2120 Instalacja
Przeglądaj online lub pobierz pdf Instalacja dla Sprzęt muzyczny Drawmer SP2120. Drawmer SP2120 1 stron. Speaker protector
Również dla Drawmer SP2120: Instrukcja obsługi (9 strony)
Drukuj stronęDrawmer have gone to great lengths to make the Speaker Protector tamper-proof by incorporating the locking mechanism on the front. However, if the rear of the unit, along with the
power amplifier, were reconnected, by an engineer/dj trying to gain more level, then the protection system would effectively be bypassed. For this reason Drawmer have designed the
Speaker Protector Tamper-proof Bracket - trapping the XLR's in place and making it extremely difficult to disconnect them without removing the bracket. This bracket could be specified
in order to conform to Local Authority noise abatement regulations.
SP2120
Speaker Protector Tamper-proof Bracket
INSTALLATION
Installation of the Tamper-proof bracket could not be simpler:
After setting up the SP2120 Speaker Protector as described in the manual,
with the XLR's in place, simply slide the Tamper-proof Bracket over the rear of
the unit, making sure that the protruding cables locate through the gaps on the
bracket. Next, screw in to place at the four locating points (arrowed) using the
M3 screws provided. Further protection can be gained by fitting M3 TORX
tamperproof screws, to a maximum length of 6mm, though a specialist
screwdriver will also be required.
In addition, for extra protection, both the SP2120 and the power amp should be
locked in a rack, where access to the rear is very difficult.
You should note that the Tamper-proof bracket is only available for SP2120's
who's serial number is 0845 or higher (September 2006). On older versions the
bracket could be retro- fitted, though this would invalidate any warranty that
Drawmer has provided for the SP2120. Alternatively, Drawmer could bring your
SP2120 up to current Drawmer specification - please contact your local distributor
or email: [email protected] for further details.