Bosch Benchmark HBLP451RUC 서비스 매뉴얼 - 페이지 25
{카테고리_이름} Bosch Benchmark HBLP451RUC에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Benchmark HBLP451RUC 45 페이지. Built-in wall ovens
Bosch Benchmark HBLP451RUC에 대해서도 마찬가지입니다: 사양 (3 페이지), 설치 매뉴얼 (39 페이지), 설치 매뉴얼 (22 페이지)
페이지 인쇄
58300000181895 ARA EN A
5. Carefully slide the oven out of the cutout to gain access to the
front and rear top housing covers.
6. Remove the top housing covers.
7. Remove the control panel.
8. Remove all of parts identified with a in Figure 34, labeling wires
prior to disconnecting, as necessary, until the top insulation
retainer is reached and the HTC is accessible.
Figure 34 Accessing the latch/HTC on the top insulation retainer
9. Disconnect the wires and remove the HTC.
10. Install the new HTC.
11. Reinstall or reposition the latch motor assembly.
12. Reinstall all parts, reconnecting wires, as necessary. (Refer to the
Service Guide (wire diagram) attached to the inside of the access
panel on the top front housing cover for reference.)
13. Restore power and test operation.
14. Slide the oven back into the cutout and resecure the oven to the
cabinetry with the original trim screws.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
6.5
The control panel includes...
Front panel assembly: stainless steel skin, touch panel
assembly, and touch control module (TCM)
Sheet metal carrier
Display module, which is mounted to the carrier
The front panel assembly is offered as the service replacement for the
stainless skin, user interface (touch panel), and/or TCM. These
components are not available separately.
The touch control module (TCM) is an electronic module which
monitors, qualifies, and transmits the inputs from the touch panel to
the user interface. It is connected to the user interface by a 4-wire
harness. The user interface, in turn, is connected to the control
module by a 3-wire harness. After start-up, the user interface polls the
TCM every 100ms to determine which, if any, keys are activated. The
response to each key press is controlled by the user interface.
The 4.3" TFT LCD display module is available separately.
A Front Panel Test is available in Service mode. See the Service
Mode section for details.
Figure 35 Control panel for Benchmark series single oven
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
Control Panel
Page 25 of 45
800 944-2904