Bosch HB 43S Series 사용 설명서 - 페이지 11

{카테고리_이름} Bosch HB 43S Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch HB 43S Series 24 페이지.

페이지 인쇄

1. Control Panel

Cleaning function

The cleaning function regenerates the self-cleaning surfaces

inside the oven.

The inside rear and side walls and ceiling of some ovens may

be lined with a highly porous ceramic lining. This lining absorbs

splashes produced during baking and roasting, dissolving them

while the oven is on. This cleaning system makes it possible to

regenerate self-cleaning surfaces that can not properly clean

themselves.

Before cleaning

Remove all pans and unsuitable accessories from inside the

oven.

Cleaning the oven's base and enamelled walls

Before programming the clean function, clean the surfaces

inside the oven that are not self-cleaning. Otherwise, stains will

appear that are impossible to remove.

Use a cleaning cloth and hot water with a little soap or vinegar.

If very dirty, use a fine steel scourer or a special oven cleaning

product. These must only be used when the oven interior is

cold. Do not use metal scourers or special oven cleaning

products on self-cleaning surfaces.

Setting

Cleaning takes approximately one hour.

Turn the control knob to Hot Air

Turn the temperature knob to

Press the

button.

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright

appearance and operating performance for many years to

come. Advice on how to care for and clean your oven is

provided below.

Notes

Different colours may be seen in your front panel due to the

■

various materials used in its manufacture, such as glass,

plastic and metal.

Dark patches in the door's glass panel may seem to be dirt

■

but they are in fact reflections from the oven light.

Enamel burns at very high temperatures. This may cause

■

slight discolouration. This is normal and does not affect the

oven's operation. The edges of thin baking trays may not be

completely enamelled. They may therefore feel slightly rough,

although their corrosive protection will be unaffected.

Cleaning products

Follow the indications provided in the table to avoid damaging

the various oven surfaces by using unsuitable cleaning

products. Do not use

abrasive or acidic cleaning products

■

strong products containing alcohol

■

scourers or hard sponges

■

high-pressure or steam cleaners

■

Wash new dishcloths thoroughly before use.

The display panel shows the

cleaning finishes, and the

brackets. Self-cleaning starts within a few seconds. The

cleaning time is displayed and the

brackets. The

symbol switches off.

The cleaning has finished

A beep will sound. The oven will stop heating. The display

panel will show

‹‹

. Press the

function control knob to position

To cancel cleaning

Press the

button and turn the function control knob to the

setting. The oven switches off.

Delaying the end time

The time at which cleaning finishes can be changed. Thus,

for example, the oven can be cleaned at night leaving it free for

use during the day.

Program as described in point 1 to 3. Before cleaning is

finished, delay the end time using the

The oven is set to standby. The time when the cleaning will be

finished is displayed and the

brackets. When cleaning begins, the time is displayed and

the

symbol appears between square brackets. The

symbol switches off.

After cleaning

Once the inside of the oven has cooled, clean the ash remains

from the self-cleaning surfaces using a damp cloth.

Zone

Front panel

Stainless steel

Glass panel

Display

Glass panels on oven

door

symbol. Displays the time

symbol appears between

button twice and turn the

. The oven switches off.

buttons.

symbol will be shown in square

Cleaning products

Hot water and a little soap:

Clean with a dishcloth and dry with a

soft cloth. Do not use a glass clean-

ing product or a glass scraper.

Hot water and a little soap:

Clean with a dishcloth and dry with a

soft cloth. Immediately remove any

water marks, grease, cornflower or

egg white stains since corrosion

could occur underneath these marks

or stains.

Special products for the care of

stainless steel and which are suita-

ble for hot surfaces may be obtained

from Technical Assistance Service

centres and specialist retail outlets.

Use a very fine soft cloth to apply

the cleaning product.

Glass cleaning products:

Clean using a soft cloth. Do not use

a glass scraper.

Glass cleaning products:

Clean using a soft cloth. Do not use

alcohol, vinegar or other abrasive or

acidic cleaning products.

Glass cleaning products:

Clean using a soft cloth. Do not use

a glass scraper.