Bosch HB 43S Series Manual de instruções - Página 11
Procurar online ou descarregar pdf Manual de instruções para Forno Bosch HB 43S Series. Bosch HB 43S Series 24 páginas.
Imprimir página
Cleaning function
The cleaning function regenerates the self-cleaning surfaces
inside the oven.
The inside rear and side walls and ceiling of some ovens may
be lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning system makes it possible to
regenerate self-cleaning surfaces that can not properly clean
themselves.
Before cleaning
Remove all pans and unsuitable accessories from inside the
oven.
Cleaning the oven's base and enamelled walls
Before programming the clean function, clean the surfaces
inside the oven that are not self-cleaning. Otherwise, stains will
appear that are impossible to remove.
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
Setting
Cleaning takes approximately one hour.
Turn the control knob to Hot Air
1.
Turn the temperature knob to
2.
Press the
button.
u
3.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners
■
Wash new dishcloths thoroughly before use.
N
.
s
.
The display panel shows the
cleaning finishes, and the
brackets. Self-cleaning starts within a few seconds. The
cleaning time is displayed and the
brackets. The
p
symbol switches off.
The cleaning has finished
A beep will sound. The oven will stop heating. The display
panel will show
‹‹
:
‹‹
. Press the
function control knob to position
To cancel cleaning
Press the
u
button and turn the function control knob to the
setting. The oven switches off.
Delaying the end time
The time at which cleaning finishes can be changed. Thus,
for example, the oven can be cleaned at night leaving it free for
use during the day.
Program as described in point 1 to 3. Before cleaning is
finished, delay the end time using the
The oven is set to standby. The time when the cleaning will be
finished is displayed and the
brackets. When cleaning begins, the time is displayed and
the
symbol appears between square brackets. The
r
symbol switches off.
After cleaning
Once the inside of the oven has cooled, clean the ash remains
from the self-cleaning surfaces using a damp cloth.
Zone
Front panel
Stainless steel
Glass panel
Display
Glass panels on oven
door
u
symbol. Displays the time
p
symbol appears between
r
symbol appears between
0
button twice and turn the
Û
. The oven switches off.
or
buttons.
@
A
symbol will be shown in square
p
Cleaning products
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass clean-
ing product or a glass scraper.
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or
egg white stains since corrosion
could occur underneath these marks
or stains.
Special products for the care of
stainless steel and which are suita-
ble for hot surfaces may be obtained
from Technical Assistance Service
centres and specialist retail outlets.
Use a very fine soft cloth to apply
the cleaning product.
Glass cleaning products:
Clean using a soft cloth. Do not use
a glass scraper.
Glass cleaning products:
Clean using a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass cleaning products:
Clean using a soft cloth. Do not use
a glass scraper.
Û
p
11