AirStage UTY-LNH series 운영 매뉴얼 - 페이지 11
{카테고리_이름} AirStage UTY-LNH series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirStage UTY-LNH series 15 페이지. Air conditioner remote controller wireless type
AirStage UTY-LNH series에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)
페이지 인쇄SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE
When 2 or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other than the one
you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to set (4 selections pos-
sible).
When 2 or more air conditioners are installed in a room, please contact authorized service personnel to set the individual air conditioner
signal codes.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote control unit. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been set for
the signal code.)
1
Press the "START/STOP" button until only the clock is
displayed on the remote control unit display.
2
Press the "MODE" button for at least 5 seconds to dis-
play the current signal code (initially set to ).
3
Press the "
change the signal code between
the code on the display to the air conditioner signal
code.
4
Press the "MODE" button again to return to the clock
display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock display.
In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact authorized service personnel to change the signal code.
The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a signal
code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
which operates the air conditioner.
SET TEMP. / SET TEMP.
" button to
. Match
) until you fi nd the code
En-10