AirStage UTY-LNH series Operating Manual - Page 11

Browse online or download pdf Operating Manual for Remote Control AirStage UTY-LNH series. AirStage UTY-LNH series 15 pages. Air conditioner remote controller wireless type
Also for AirStage UTY-LNH series: Operating Manual (16 pages)

Print Page

1. Selecting the Remote Control Unit Signal Code

SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE

When 2 or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other than the one

you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to set (4 selections pos-

sible).

When 2 or more air conditioners are installed in a room, please contact authorized service personnel to set the individual air conditioner

signal codes.

Selecting the Remote Control Unit Signal Code

Use the following steps to select the signal code of the remote control unit. (Note that

the air conditioner cannot receive a signal code if the air conditioner has not been set for

the signal code.)

Press the "START/STOP" button until only the clock is

displayed on the remote control unit display.

Press the "MODE" button for at least 5 seconds to dis-

play the current signal code (initially set to ).

Press the "

change the signal code between

the code on the display to the air conditioner signal

code.

Press the "MODE" button again to return to the clock

display. The signal code will be changed.

If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock display.

In this case, start again from step 1.

The air conditioner signal code is set to A prior to shipment. Contact authorized service personnel to change the signal code.

The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a signal

code other than signal code A, reset the signal code after replacing the batteries.

If you do not know the air conditioner signal code setting, try each of the signal codes (

which operates the air conditioner.

SET TEMP. / SET TEMP.

" button to

. Match

) until you ﬁ nd the code

En-10