Bosch HBA36B6.0W 사용 설명서 - 페이지 17
{카테고리_이름} Bosch HBA36B6.0W에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch HBA36B6.0W 36 페이지. Built-in oven
페이지 인쇄Removal
Detach the oven door and lay on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$
Unscrew the retaining clips on the right and left and remove
4.
them (fig. C). Remove the middle panel.
&
Pull the lower panel diagonally upwards and out.
5.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
:
appears in the display.
‹‹
‹‹
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. A small
square lights up in the temperature dis-
play.
%
Possible cause
Defective fuse
Power cut
Type of heating not recognised
The oven is in demo mode.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
Insert the lower panel diagonally towards the back (fig. A).
1.
Insert the centre panel (fig. B).
2.
$
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
&
Insert the uppermost panel diagonally towards the back. The
4.
smooth surface must face outwards.
Put the cover back in place and screw it on.
5.
Attach the oven door.
6.
Do not use the oven again until the panels have been
correctly fitted.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the clock.
Make the settings again.
Switch off the circuit breaker in the fuse box, then
switch it back on after at least 20 seconds. Within
the next 2 minutes, press and hold the
for 4 seconds until the square disappears from the
display.
%
button
D
17