Electrolux EFLS210TIS 사용 및 관리 매뉴얼 - 페이지 2
{카테고리_이름} Electrolux EFLS210TIS에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EFLS210TIS 22 페이지. Front load dryer
Electrolux EFLS210TIS에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (29 페이지)
페이지 인쇄
2
Important Safety Instructions
Keep a record for quick
reference
Purchase date
Electrolux model number
Electrolux serial number
Read all instructions before using this
appliance. This book contains valuable
information about:
• Operation
• Care
• Service
Keep it in a safe place.
This Use & Care Guide provides general
operating instructions for your dryer. It also
contains information about features for several
other models. Your dryer may not have every
feature included.
Use the dryer only as instructed in this Use &
Care Guide.
NOTE
The instructions appearing in this Use &
Care Guide are not meant to cover every
possible condition and situation that may
occur. Common sense and caution must
be practiced when installing, operating and
maintaining any appliance.
Table of Contents
Important Safety Instructions ....................... 2
Features ...................................................... 5
Operating Instructions ................................. 6
Controls and Settings .................................. 9
Care and Cleaning ..................................... 14
Solutions to Common Problems ................ 17
Limited Warranty ....................................... 19
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Thank you for choosing an Electrolux
Compact Ventless Dryer. This dryer operates
on a different drying principle than traditional
exhaust ducted dryers. Your new dryer is a
condensation, ventless dryer and DOES NOT
require exhaust venting that exhausts the
drying process air to the outside.
A condensation dryer works through a closed
loop circuit. The drying process air is heated
by an internal heating element, which then
passes over and through your clothes. The
moisture rich air proceeds down through a lint
filter, then through an air-air heat exchanger
that works as a condenser. The warm, wet
air is cooled by a separate secondary fan that
utilizes ambient room air. When the process
air cools down, it releases moisture that is
collected in a recovery basin at the bottom
of the appliance. The water can be either
pumped down the drain by the provided kit, or
pumped directly into a tank that needs to be
emptied after each drying cycle.
IMPORTANT
Your new dryer is a condensation, ventless
dryer and DOES NOT require exhaust
venting that exhausts the drying process air
to the outside.
8
4
3
5
1
6
1. Primary circuit -
drying process
air fan
2. Heating element
3. Lint filter
4. Clothes load
5. Heat exchanger
10
2
9
11
7
6. Secondary circuit -
ambient air fan
7. Drain water basin
8. Water tank
9. Float/pump switch
10. Water drain tube
11. Water pump