Draytek VigorAP 810 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Draytek VigorAP 810에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorAP 810 10 페이지. 802.11n
Draytek VigorAP 810에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지)

페이지 인쇄
Draytek VigorAP 810 빠른 시작 매뉴얼

Installation

This section will guide you to install the AP through hardware connection and
configure the settings through web browser.
Before starting to configure the router, you have to connect your devices correctly.
1. Connect VigorAP 810 to ADSL modem, router, or switch/hub in your
network through the LAN A port of the access point by Ethernet cable.
Note: You can also connect VigorAP 810 to a Vigor router via wireless
connection. For detailed information, refer to VigorAP 810 User's Guide.
2. Connect a computer to other available LAN A port. Make sure the subnet IP
address of the PC is the same as VigorAP 810 management IP, e.g.,
192.168.1.X.
3. Connect the A/C power adapter to the wall socket, and then connect it to the
PWR connector of the access point.
4. Power on VigorAP 810.
5. Check all LEDs on the front panel. ACT LED should be steadily on, LAN
LEDs should be on if the access point is correctly connected to the ADSL
modem, router or switch/hub.