Draytek VigorAP 810 Hızlı Başlangıç Kılavuzu - Sayfa 6
Kablosuz Erişim Noktası Draytek VigorAP 810 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Draytek VigorAP 810 10 sayfaları. 802.11n
Ayrıca Draytek VigorAP 810 için: Hızlı Başlangıç Kılavuzu (9 sayfalar)
Sayfayı Yazdır
Installation
This section will guide you to install the AP through hardware connection and
configure the settings through web browser.
Before starting to configure the router, you have to connect your devices correctly.
1. Connect VigorAP 810 to ADSL modem, router, or switch/hub in your
network through the LAN A port of the access point by Ethernet cable.
Note: You can also connect VigorAP 810 to a Vigor router via wireless
connection. For detailed information, refer to VigorAP 810 User's Guide.
2. Connect a computer to other available LAN A port. Make sure the subnet IP
address of the PC is the same as VigorAP 810 management IP, e.g.,
192.168.1.X.
3. Connect the A/C power adapter to the wall socket, and then connect it to the
PWR connector of the access point.
4. Power on VigorAP 810.
5. Check all LEDs on the front panel. ACT LED should be steadily on, LAN
LEDs should be on if the access point is correctly connected to the ADSL
modem, router or switch/hub.