Draytek VigorAP 903 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Draytek VigorAP 903에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draytek VigorAP 903 13 페이지. 802.11ac access point
Draytek VigorAP 903에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (16 페이지)

페이지 인쇄
Draytek VigorAP 903 빠른 시작 매뉴얼

Installation

This section will guide you to install the AP through hardware / wall-mounting
connection.
For hardware connection, refer to the following steps to connect your devices
correctly.
1. Connect VigorAP 903 to xDSL modem, router, or switch/hub in your
network through the LAN A port of the access point by Ethernet cable.
Note
2. Connect a computer to other available LAN A port. Make sure the subnet IP
address of the PC is the same as VigorAP 903 management IP, e.g.,
192.168.1.X.
3. Connect the A/C power adapter to the wall socket, and then connect it to the
PWR connector of the access point.
4. Power on VigorAP 903.
5. Check all LEDs on the front panel. ACT LED should blink, LAN LEDs
should be on if the access point is correctly connected to the xDSL modem,
router or switch/hub.
You can also connect VigorAP 903 to a Vigor router via
wireless connection. For detailed information, refer to
VigorAP 903 User's Guide.