BDS MABasic 200 원본 사용 설명서 - 페이지 11

{카테고리_이름} BDS MABasic 200에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BDS MABasic 200 20 페이지.
BDS MABasic 200에 대해서도 마찬가지입니다: 원본 사용 설명서 번역 (20 페이지)

페이지 인쇄

MABasic 200 and 400

Insert the core drill into the direct tool

mount (illustration A)

Before mounting, clean the Weldon

shank and direct tool mount (2) of the

machine.

Check the the lead connection for

lubricant.

Unscrew the two Allen screws in the

direct tool mount using the hexagonal

offset screwdriver (24) supplied.

Insert the core drill in the direct tool

mount (2).

NOTE

►

Insert the appropriate ejector pin (22)

before inserting the core drill.

Tighten the two Allen screws in the di-

rect tool mount (2) using the hexagonal

offset screwdriver (24) supplied.

Removing the tool

Unscrew the two Allen screws in the

tool mount (2) using the hexagonal

offset screwdriver (24) supplied and

remove the core drill from below.

MABasic 200, 400, 450, 850

MABasic 450 and 850

Insert the core drill into the industrial

holder (illustration B)

Push the industrial holder (25) into the

spindle taper of the machine.

Before inserting, clean the Weldon

shank of the tool and the tool holder.

Check the the lead connection for

lubricant.

Unscrew both Allen screws in the tool

mount using the hexagonal offset

screwdriver (24) supplied.

Insert the core drill into the tool mount.

NOTE

►

Insert the appropriate ejector pin (22)

before inserting the core drill.

Tighten both Allen screws in the tool

mount (2) using the hexagonal offset

screwdriver (24) supplied.

Removing the tool

Unscrew the two Allen screws in the

tool mount (2) using the hexagonal

offset screwdriver (24) supplied and

remove the core drill from below.

Preparation