Anchor AL-WB 소유자 매뉴얼 - 페이지 4
{카테고리_이름} Anchor AL-WB에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AL-WB 4 페이지. Uhf tour guide system
Anchor AL-WB에 대해서도 마찬가지입니다: 사양 (1 페이지)
페이지 인쇄
BELT PACK TRANSMITTER SETUP
Model: WB-6000
Belt pack transmitter for use with Anchor Audio 16 channel belt
pack receivers. The transmitter operates in the UHF band frequen-
cy and is powered by two DC 1.5V "AA" size batteries.
BELT PACK SETUP
1. INSERT BATTERIES: Open battery compartment by gently
push/sliding door. Insert two "AA" batteries.
2. SET CHANNEL: Using the included screwdriver turn the
Channel Selection Dial to the same channel as the receiver.
CHANNEL
SELECTION DIAL
NOTE: The transmitter and receiver MUST be set
to the same channel to operate correctly.
3. CONNECT MICROPHONE: Insert the headband micro-
phone plug into the jack labeled INPUT located on top of
the transmitter.
4. POWER ON: Slide transmitter power switch to "ON". The
red LED will flash when the mic is turned on, if the LED
stays on, the batteries are low and need to be replaced.
NOTE: If you experience ongoing interference with
your wireless system, the selected frequency may
be incompatible w/ other systems in the area!
Try different channels to find a clear frequency!
BASE STATION TRANSMITTER SETUP
The Base station transmitter is for use with Anchor Audio 16 channel belt pack receivers. The transmitter operates in the UHF band frequency on 16 channels and is
powered by an included AC power adapter.
BASE STATION SETUP
1. CONNECT ANTENNA: Attach the UHF antenna to the Antenna Socket
labeled RF OUT on the rear panel.
2. CONNECT POWER: Plug the AC adapter into the DC Input Jack on the rear
panel. Then plug the AC adapter into a power outlet.
3. SETUP INPUT SOURCE: Connect a wired microphone to the Microphone
Input Jack on the rear panel. Adjust the MIC Volume Control knob on
the front panel to set level. Use the RCA Input Jack on the rear panel to
connect a stereo audio device. Adjust the Line In Volume Control knob on
the front panel to set level.
POWER
MIC VOLUME CONTROL
CHANNEL DISPLAY LED
CHANNEL SELECTION KNOB
WIRELESS TRANSMITTER
Model: AL-TX
NOTE: If you experience ongoing interference with your wireless system, the selected frequency may be
incompatible with other systems in the area! Try different channels to find a clear frequency!
4. SET CHANNEL: Press the Power button on the front panel to turn on the
transmitter. Turn the Channel Selection Knob to the channel you chose.
NOTE: Transmitter & receiver MUST be set to the same channel.
5. MONITOR TRANSMISSION: For monitoring purposes, plug headphones
into the Monitoring Headphone Jack on the front panel. Adjust the head-
phone volume with the Monitoring Headphone Volume Control knob.
MONITORING HEADPHONE VOLUME CONTROL
LINE IN VOLUME CONTROL
MICROPHONE INPUT JACK
ANTENNA SOCKET
PEAK INDICATOR
MONITORING HEADPHONE JACK
RCA INPUT JACK
STEREO/MONO SWITCH
DC INPUT JACK
5