Anchor NAV50-1204 사용자 설명서 - 페이지 13

{카테고리_이름} Anchor NAV50-1204에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor NAV50-1204 18 페이지. 50’ wide frame tent system

HIP END MODULES

FOR RECTANGULAR UNITS

THE RECTANGULAR UNIT IS SIMPLY (2) HIP

ENDS FACING EACH OTHER AND SEPARATED

BY PARALLEL-BEAMED MIDDLE BAYS.

COMPLETING THE HIP END

LIFT SECOND (OPPOSITE) SIDE OF THE

HIP END AND PIN UPRIGHTS INTO POSI-

TION. INSTALL UPRIGHT BRACES AT

INTERMEDIATE POSITIONS. THE CROSS-

CABLE REMAINS AS A PERMANENT PART

OF THE 50' NAVI-TRAC UNIT.

FABRIC NOT SHOWN

LIFT FIRST SIDE AND INSTALL UPRIGHTS (WITH

UPRIGHT BRACES AT INTERMEDIATE LOCATIONS).

NOTE: ONLY FIXED-BASE UPRIGHTS

ARE TO BE USED IN END MODULES.

FOR RECTANGULAR UNITS, FIRST CONSTRUCT

HIP ENDS, INSTALLING FABRIC LOOSELY AND

RAISING EACH SIDE TO INSTALL UPRIGHTS AND

BRACES, JUST AS IN THE SQUARE TENT IN

PRECEDING PAGES.

THE HIP END FABRIC IS INSTALLED THE SAME AS

ON SQUARE UNITS (SEE ILLUSTRATION #9-B).

NOTE: BEFORE INSTALLING FABRIC, BE SURE

ALL PINS AND BOLTS ARE PROPERLY SEATED

AND SECURED WITH LANYARD PINS AS NEEDED.

12-T

12-B