Electrolux AUCI 설치, 운영 및 유지보수 매뉴얼 - 페이지 18

{카테고리_이름} Electrolux AUCI에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux AUCI 20 페이지. Undercounter dishwasher
Electrolux AUCI에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)

페이지 인쇄

Open the power supply terminal board and insert the

jumpers provided as follows: one jumper between termi-

nals 2 and 4 and another between terminals 4 and 6.

Using a suitable power supply cable (see technical data

table), connect the three phases to terminals 1, 3 and 5,

the neutral to terminal 6 and the earth wire to the termi-

nal

Power supply 400...440V 3

Figure 9

Open the power supply terminal board and insert the

jumpers provided as follows: one jumper between termi-

nals 2 and 4 and another between terminals 4 and 6.

Using a suitable power supply cable (see technical data

table), connect the three phases to terminals 1, 3 and 5

and the earth wire to the terminal

Power supply 220...230V 3

Figure 10

Open the power supply terminal board and insert the

jumpers provided as follows: one jumper between termi-

nals 1 and 2, one between terminals 3 and 4 and

another between terminals 5 and 6. Using a suitable

power supply cable (see technical data table), connect

the three phases to terminals 1, 3 and 5 and the earth

wire to the terminal

Power supply 220...230V 1N

Figure 11

Open the power supply terminal board and insert the

jumpers provided as follows: two jumpers between ter-

minals 1, 3, 5 and another two between terminals 2, 4

and 6.

Using a suitable power supply cable (see technical data

table), connect the phase and neutral to terminals 5 and

6 respectively and the earth wire to the terminal

Connections provided for energy control

This appliance is designed for an external energy con-

sumption control.

Figure 12

Connect the energy peak controller across terminals 11

and 12.

CAUTION

A normally open (n.o.) contact of the

controller must be connected across

terminals 11 and 12. When this contact

closes the boiler heating elements are

disconnected. Using the dishwasher in

these conditions may increase the cycle

time.

Safety devices

•

An automatic reset thermoamperometric protective

device incorporated in the windings of the electric

pump cuts off the electricity supply in the case of

malfunctioning.

•

In the event of water mains failure, a device pre-

vents water in the boiler from returning into the

mains.

•

An overflow pipe, connected to the drainage outlet,

maintains the water in the tank at a constant level.

•

On models with a drain pump, a supplementary

level control device activates if the main level con-

trol device is faulty.

Failure to comply with safety rules and regulations

relieves the manufacturer of all liability.

WARNING MESSAGES DISPLAYED ON THE

CONTROL PANEL

NO WATER

Check that the cock is open.

Check that the water inlet filter is clean.

Check the minimum mains pressure (not less than

50 kPa).

Check that the overflow pipe is inserted (for

appliances without drain pump only).