Anchor AF-4003 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Anchor AF-4003에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AF-4003 10 페이지. Under counter water filter system
Anchor AF-4003에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (9 페이지), 빠른 설정 매뉴얼 (9 페이지)

페이지 인쇄

FAUCET INSTALLATION

Drilling the Faucet Hole

NOTE: Safety glasses should be worn to protect your eyes while drilling the faucet hole.

Be sure there is room underneath the sink to make the needed connections. Select one of the

following locations to install the faucet:

• In an existing sink spray attachment or soap dispenser hole.

• In a hole to be drilled in the sink top.

• In a hole to be drilled in the countertop, next to the sink.

NOTE: Be sure the faucet base will fit flat against the surface at the selected location

so the gasket will seal.

For best results, a ½" carbide-tipped drill bit should be used to drill a hole into your sink for the

auxiliary faucet.

Carefully select the faucet location making sure it will have a neat water fall pattern and that the

faucet stud will be accessible from below once the hole is completed.

For Porcelain Sink: Before starting the drill motor, apply firm downward pressure on the bit until

a crunching occurs. This will help keep the drill bit from moving.

For Stainless Steel Sink: Before using a ½" carbide drill bit, an indent should be made with a center

punch to keep the drill bit from moving. A small pilot hole will also aid the ½" drill bit.

For best results, keep steady firm pressure during the start of the hole will cause excess wear on

the bit and progress will be slow.

Once the hole is complete, clean the area of metal chips and roughness around the hole. Metal

chips will stain

Figure # 4

7 |

P a g e