Anchor AF-4003 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} Anchor AF-4003에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor AF-4003 10 페이지. Under counter water filter system
Anchor AF-4003에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (9 페이지), 빠른 설정 매뉴얼 (9 페이지)
페이지 인쇄
START-UP PROCEDURE
1.
Check to see all connections are made.
2.
Check that the pre-filter and pre-carbon sumps are secure using the housing wrench provided.
3.
Slowly turn on the water by turning the needle valve counterclockwise.
4.
The handle of the faucet should be perpendicular to the spigot (closed).
5.
Check for leaks.
WARNING: Before using the filter system for the first time, the system must be purged.
The filter system cartridge contains a food grade preservative that must be purged from
the system. The preservative will give product water an unpleasant taste and odor.
If you have any difficulties with the installation, or require additional information on your unit,
please consult with our factory technicians.
RECOMMENDED MAINTENANCE
1.
Sediment Pre-filter: The pre-filter protects the system and should be maintained
regularly, a clear housing has been provided for your convenience. The show-white pre-
Filter should be changed when the outside discolors to a cardboard brown color and
before the inner surface discolors. The life of the pre- filter will depend upon the condition
of your water supply and should be checked at 6-month intervals until a filter life is
established (average life 6 months).
2. GAC and Carbon Block: Designed to remove chlorine form the water supply, as well as organic
and inorganic substance before entering the TFC membrane (average life 12 months).
3.
Post-Carbon: The post-filter should be changed when you experience an unusual taste and/or
odor to the water and has a nominal life of 1 year.
CHANGING THE SEDIMENT, GAC, AND CARBON BLOCK PRE-CARBON BLOCK PRE-
FILTERS
1.
Shut off the feed water to the system by turning the saddle valve on the water supply adapter
clockwise until it stops.
2.
Press down on faucet handle to relive pressure.
3. Allow 2-3 minutes for pressure in the system to drop
4. Remove the filter sumps with the housing wrench by turning the sump to the left
(counterclockwise). If the O- ring in the sump is stretched or worn, it should be replaced to maintain
a proper seal
5.
Remove the old filter and gaskets (if any) and insert the new filter.
6.
Replace the sump onto the cap by turning it to the right (clockwise) until the O-ring makes firm
contact, like an oil filter on a car. DO NOT OVER-TIGHTEN.
7.
Turn on the feed water to the system by turning the saddle valve at the water supply adapter
counter- clockwise.
9 |
P a g e