Anchor-Caddie TMB101 사용 설명서 - 페이지 4

{카테고리_이름} Anchor-Caddie TMB101에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor-Caddie TMB101 6 페이지. Trolling motor bracket adapter kit

Trolling Motor Bracket Adapter Kit (TMB101)

Step 4 of 8

Mount the base plate of your quick release bracket to the bow of your boat

Start by carefully removing the anchor nest, adapter kit and top plate of your quick release bracket, trying not to disturb the

location of your quick release bracket.

You will use the hardware that came with your Minn Kota or Motorguide quick release bracket and follow their instructions for

mounting the base plate.

But I will outline what I did on this installation as far as marking and drilling the mounting holes.

TIP: I was just going to use the punch with the base plate in place, but the punch wasn't long enough to get through the

plate, so I had to use a pencil first to mark it. But my pencil wouldn't fit either, so I had to shave the pencil to get in the

holes. Since I was mounting it on a black colored bow, I could not see the pencil mark, so I laid out some blue tape, so I

could see the marks.

I recommend using a punch

instead of just drilling on your

pencil mark, it will help keep the

drill from moving off your mark.

I used a spring loaded punch,

but any punch and hammer will

work.

™ 2021 Anchor-Caddie

I also recommend starting with a

smaller drill bit, again to help

prevent the drill bit from moving

off your mark. I used a 1/8" drill bit

to start, then used a 5/16" bit to

finish.

The screws that go into the base

plate are ¼", but I wanted to have a

little wiggle room in case my holes

were off a little.

Use anti-seize in this step!

Use the manufacturer's

hardware and instructions to

mount the base plate to your

bow.

Use anti-seize in this

For my installation, I found that

their screws were too long, and I

didn't want to have to drive the

locknut that far, so I installed

shorter screws. Your installation

my vary.

step.

Page 4 of 6