Anchor-Caddie TMB101 사용 설명서 - 페이지 2

{카테고리_이름} Anchor-Caddie TMB101에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor-Caddie TMB101 6 페이지. Trolling motor bracket adapter kit

Trolling Motor Bracket Adapter Kit (TMB101)

Step 1 of 8

Mount your Anchor Caddie anchor nest to the Top Mounting Plate.

Use the diagram below to choose which holes you will mount your Anchor Caddie anchor nest to.

Original

Anchor

Caddie

5/16-18 x 3/4"

Screw (3)

5/16-18 x 1-

1/4" Screw (2)

Step 2 of 8

Mount your Bottom Mounting Plate to your Base Bracket.

At this point, you just want to put in 1 screw with flat and lock washer in the center of your Base Bracket and the center

hole of your Bottom Mounting Plate as shown below. Just hand tighten so you can adjust your angle later.

™ 2021 Anchor-Caddie

Anchor

Caddie

PRO

This is where you want to use the anti-seize

compound. Put a little dab inside the nuts. It

doesn't take much but will keep the stainless steel

hardware from seizing up to where you can't

complete the tightening or remove it if necessary.

Once you have this done, it's time to dry fit everything on the bow of

your boat, including your Minn Kota or Motorguide quick release

bracket.

This is where you make the necessary angle and overhang adjustments

to get your anchor nest centered on the bow.

Let's go out to the boat.

Anchor

You will use the hardware

Caddie

labeled "Step 1".

Cadet

If you are installing the

Original, you will use the 2

longer screws in the back that

has the black impact plate.

Page 2 of 6