Anchor-Caddie TMB101 Talimatlar Kılavuzu - Sayfa 2

Tekne Ekipmanları Anchor-Caddie TMB101 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Anchor-Caddie TMB101 6 sayfaları. Trolling motor bracket adapter kit

Trolling Motor Bracket Adapter Kit (TMB101)
Step 1 of 8
Mount your Anchor Caddie anchor nest to the Top Mounting Plate.
Use the diagram below to choose which holes you will mount your Anchor Caddie anchor nest to.
Original
Anchor
Caddie
5/16-18 x 3/4"
Screw (3)
5/16-18 x 1-
1/4" Screw (2)
Step 2 of 8
Mount your Bottom Mounting Plate to your Base Bracket.
At this point, you just want to put in 1 screw with flat and lock washer in the center of your Base Bracket and the center
hole of your Bottom Mounting Plate as shown below. Just hand tighten so you can adjust your angle later.
™ 2021 Anchor-Caddie
Anchor
Caddie
PRO
This is where you want to use the anti-seize
compound. Put a little dab inside the nuts. It
doesn't take much but will keep the stainless steel
hardware from seizing up to where you can't
complete the tightening or remove it if necessary.
Once you have this done, it's time to dry fit everything on the bow of
your boat, including your Minn Kota or Motorguide quick release
bracket.
This is where you make the necessary angle and overhang adjustments
to get your anchor nest centered on the bow.
Let's go out to the boat.
Anchor
You will use the hardware
Caddie
labeled "Step 1".
Cadet
If you are installing the
Original, you will use the 2
longer screws in the back that
has the black impact plate.
Page 2 of 6