Formax FD 90 운영자 매뉴얼 - 페이지 8

{카테고리_이름} Formax FD 90에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 90 11 페이지. Rotary perforators
Formax FD 90에 대해서도 마찬가지입니다: 운영자 매뉴얼 (11 페이지)

Outfeed table adjustment

Adjust the output table (2) by sliding the table outward, depending on the size of the sheet being processed.

For easier stacking of larger sheets attach the bridge (11) and magnetic side guides (10). These facilitate sheet stacking and

substantially reduce paper jamming.

Note: If the table is not extended above the pad, do not overload it, as the table might become damaged or bent.

Start the machine by pressing the power switch (7). Be sure the upper cover (5) is closed. When the upper cover is closed

and paper is loaded correctly on the infeed table, the machine will automatically begin to feed paper and the red LED (12)

will list. When the paper runs out or the upper cover is opened, the LED will blink.

Replacing & Adjusting Perforating Tools or Creasing Wheels

To adjust the perforating tools (21, 27) or the creasing wheels (26), first unplug the machine. Open the cover (5) and use

an Allen wrench to loosen the screws on the hubs of the blade guides (22) and remove the shaft with the bled guides from

the machine.

Loosen the screws on the hubs of all tools you want to adjust or remove. Loose tools can be moved freely along the shafts.

When the tools are positioned, the screws must be tightened and the tools secured in the required position. Return the shaft

with the blade guides into the machine to its working position near the perforating wheels.

It is possible to install a maximum of 5 perforating tool sets including the blade guide (28). (Two sets of perforating tools are

include.)