Athena BATHROOMS Fleet Vanity 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Athena BATHROOMS Fleet Vanity에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Athena BATHROOMS Fleet Vanity 8 페이지.

Installing the Fleet Drawer continued

6. Return the Drawer box into the Drawer body. Ensure that

the rear clips of the runners are engaged into the rear of

the drawer box.

Please refer to the last page of the instructions for detailed

Drawer runner installation & adjustment.

Fitting the Bench Top & Basin

1. Place and position the bench top onto the Fleet Frame's

top surface.

2. Place the basin on the bench top and mark the waste

position.

3. Mark the position of the tapware if it is to be mounted

on the bench top. Please check to ensure there is

enough space behind the basin being installed. Larger

basins may require tapware to be mounted slightly to

the side. Note: there is a 45mm cavity behind the

drawer to accommodate flexible hoses.

4. Through the centre of the basin waste and tap hole, drill a

pilot hole into the bench top and top of the Fleet Frame.

5. Remove the Benchtop and place on a firm flat surface.

Using a hole saw cut the appropriate size holes for the

waste fitting and the tap. A jigsaw with a high speed steel

blade can be used to cut the waste hole. If using a jigsaw,

mask the immediate area to protect the surface. Do not

cut square corners, corners must have a minimum 10mm

radius. If required, any cut edges can be smoothed using a

medium grit sandpaper.

6. Drill or cut the top surface of the Fleet Frame to accommo-

date the waste fitting & tap. When cutting the hole for the

waste and tap, it is recommended that the hole be larger

than that cut into the bench top e.g. if the bench top tap

hole is 35mm cut a 50mm hole in the Fleet Frame.

We suggest laying a towel inside the drawer to protect the

drawer runners being covered in debris. If any debris does

make its way onto the runners, use a vacuum cleaner to

remove.