Formica Intentek 테크인칼 매뉴얼 사용 및 관리, 보증 및 설치 매뉴얼 - 페이지 10
{카테고리_이름} Formica Intentek에 대한 테크인칼 매뉴얼 사용 및 관리, 보증 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formica Intentek 17 페이지. Wireless charging surface
페이지 인쇄INTENTEK
WIRELESS CHARGING SURFACE
™
TECHINCAL GUIDE USE & CARE, WARRANTY, AND INSTALLATON GUIDE
CONNECTING MULTIPLE ELECTRONICS MODULES TO
A SINGLE AC ADAPTER
REMINDERS:
• Up to four electronics modules can be connected with a single
power source. Use this step if the design requires multiple
electronics modules to be connected.
• 20 AWG corded wire is the minimum gauge required.
• When connecting multiple electronics units together, it is critical that
instructions are followed. The correct polarity is important, or the
electronics will not operate.
• Always use two cord colors. Formica Group recommends using a
red wire for positive and a white wire for negative.
• Always cover wire when top is finished.
• Never work with electrical wiring while powered.
INSTRUCTIONS FOR CONNECTING MULTIPLE
CHARGING ZONES TOGETHER
a) Confirm electronics are not plugged into a power source.
b) Locate the parent electronics module (the parent is the one that
will be plugged into the AC Adapter).
c) Using a wire stripper, strip 3/16" off one end of the red and white
wires to expose the wire underneath.
FTB-0918 | Rev 2 | 6/20
d) Using a small slotted screwdriver, tighten the exposed wire of
the positive (red) wire into the positive port in the parent's power
distribution board.
e) Using a small slotted screwdriver, tighten the exposed wire of the
negative (white) wire into the negative port in the parent's power
distribution board.
Sheathing coverage
for wire channels
f) Measure the length of wire needed to reach the next electronics
module and cut. Strip this end to expose 3/16" of both red and
white cords.
g) Using a small slotted screwdriver, tighten the exposed wire of
the positive (red) wire into the positive port in the second power
distribution board.
h) Using a small slotted screwdriver, tighten the exposed wire of the
negative (white) wire into the negative port in the second power
distribution board.
i) Repeat until all of electronics modules have been connected.
j) Check to be certain all wires are tight in terminal strips.
Formica Group Technical Guide
| 1 0