Formica Intentek 테크인칼 매뉴얼 사용 및 관리, 보증 및 설치 매뉴얼 - 페이지 8

{카테고리_이름} Formica Intentek에 대한 테크인칼 매뉴얼 사용 및 관리, 보증 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formica Intentek 17 페이지. Wireless charging surface

INTENTEK

WIRELESS CHARGING SURFACE

™

TECHINCAL GUIDE USE & CARE, WARRANTY, AND INSTALLATON GUIDE

CAUTION: When measuring, do not use any tools that could

damage the contact pad.

NOTE: The end with the double layer of contact pads is where the

electronics blower oulet will be.

3. PRODUCTION: CNC OPERATIONS (TYPICAL STEPS)

3A) RESET CNC: Reset CNC program for cutting to do a perimeter

cut of the deepest part of cavity (the part where the contact pads are

exposed). We do not recommend removal of material within this area

until after CNC operation is complete.

3B) POSITION BOARD: Position the decorative laminate side of

panel face down on the CNC table.

3C) ALIGN BOARD: Position the decorative laminate side of Align

reference edge of panel decorative laminate sheet to the CNC

alignment pins on the vacuum table prior to initiating the cutting

operation.

3D) WARNING: Machining must not contact the charging zone area

contact pads which will impact/defeat the performance of the end

product.

3E) RUN CNC: Run CNC program to make all cuts into the

substrate, which may include:

a. the electronics cavity or cavities into the substrate

FTB-0918 | Rev 2 | 6/20

b. wire or adapter tracks

This end is where

blower outlet will

be orientented

This is where the center

point is measured

c. attachment holes for table legs

3F) REMOVE CAVITY PIECE: When job is complete, remove cavity

substrate piece (that was created with the perimeter cut) from the

cavity to reveal the contact pads. At this time, the 5"x5" masking

should also be removed.

3G) CONFIRM CAVITY MEASUREMENT: Check to confirm the

distance from the flange where the heat sink will eventually be

screwed in to the bottom of the cavity where the contact pads are.

This measurement should be 13.31 mm. (.524 inch)

Formica Group Technical Guide

| 8