Athletica Sport Systems GlassFlex 매뉴얼 - 페이지 2

{카테고리_이름} Athletica Sport Systems GlassFlex에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Athletica Sport Systems GlassFlex 7 페이지.

페이지 인쇄

GlassFlex® adjustment

Product Manual

Thank you for purchasing the

GlassFlex® glass system

This manual will explain how to properly adjust the

leaning of the shielding in a GlassFlex® system.

This will be achieved through the process of tightening

and/or loosening U-Bolts to change the angle of the

GlassFlex® Buffer and Channel.

Each U-Bolt will have a GlassFlex® Buffer resting in it.

Typically, each section of glass channel will have two

U-Bolts to adjust, while smaller sections of glass channel

may have only one U-Bolt to adjust.

The goal is to adjust each glass channel so shielding

is not leaning too far into spectators or ice side of

dashers. Shielding should be 'level to leaning 1/4"

over 3 feet' towards ice surface.

Tools required for adjustment

1/2" Wrench

1/2" Socket (deep socket 1/4"-3/8" drive)

Section View of GlassFlex in a Dasher Panel

U-Bolt detail

Each GlassFlex Buffer is supported by a U-Bolt. The

GlassFlex® Buffer is held between the bottom of the

U-Bolt and a washer plate, which is held in place with

two nuts. There are also two nuts directly below the

3" aluminum tube at the rear of the frame. Inside this

tube are an additional washer plate and two more nuts.

All six nuts are the same size. The four nuts below the

tube require a 1/2" wrench to adjust, while the two nuts

within the tube will require a 1/2" socket (deep socket

1/4"-3/8" drive).

554 Parkside Drive, Waterloo, Ontario, Canada N2L 5Z4 TEL 519-747-1856

720 Innovation Drive, Shakopee, Minnesota, USA 55379 TEL 763-249-7465

GlassFlex® Channel

U-Bolt

GlassFlex®

Buffer

U-Bolt

1/2" Nut

found inside tube

Washer Plate

found inside tube

1/2" Nut

directly under tube

1/2" Nut

top of buffer washer plate

Buffer Washer

Plate