formlabs Form Wash 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} formlabs Form Wash에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. formlabs Form Wash 13 페이지.
페이지 인쇄TOOLS & STORAGE
11
11
LEFT STORAGE
A Flush Cutters.
B Removal Tool.
PreForm to release the base of your parts from the build platform.
C Hydrometer.
Float in IPA to measure the IPA's resin concentration,
based on previous calibration in fresh IPA. See page 5.
D Scraper.
Can be used to remove parts from the build platform, as well
as to carefully clean and inspect the resin tank for cured material.
E Tweezers.
Use to handle small parts or to manipulate supports
after printing.
F Siphon Pump.
storage container. See page 9.
11
11
Use to carefully remove support tips from printed parts.
Apply pressure under the base generated by
Transfer IPA between the wash bucket and an IPA
RIGHT STORAGE
11
3