Carmanah SpeedCheck-15 설치 매뉴얼 - 페이지 10
{카테고리_이름} Carmanah SpeedCheck-15에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah SpeedCheck-15 18 페이지. External radar kit
Carmanah SpeedCheck-15에 대해서도 마찬가지입니다: 교체 매뉴얼 (14 페이지), 교체 매뉴얼 (11 페이지), 캐비닛 도어 교체 매뉴얼 (10 페이지), 매뉴얼 (16 페이지), 설치 매뉴얼 (12 페이지)
페이지 인쇄
3. Fish the Ethernet cable (not included) to the back panel assembly and plug it into the converter. Connect
the other end to your laptop. If necessary, use the second 3/4" conduit opening to route the Ethernet
cable to the converter. This cable will eventually be connected to your network switch.
4. Reinstall the back panel assembly to the SPEEDCHECK-18 sign. Ensure nothing gets pinched in the
gasket. Tighten the four screws firmly.
5. Turn on the breaker or reinstall the fuse in the power cabinet.
6. Wait for vehicle traffic to activate the system to ensure the radar is working properly.
7. See
Section 4
to configure the converter. Once configuration is completed, disconnect the Ethernet cable
from your laptop and connect it to your network switch.
8. See
Section 5
if the sign requires programming via SpeedCheck Manager.
a. SpeedCheck Manager can be downloaded at support.carmanah.com.
Ethernet cable to network (not provided)
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
Serial to Ethernet converter
Hole plug for second conduit opening
SERIAL TO ETHERNET INSTALL GUIDE
3.0 INSTALLATION
10
|
carmanah.com