ATI Audio DDA416 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} ATI Audio DDA416에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio DDA416 14 페이지. Quad 1x4 aes/ebu distribution amplifier and 1x6 clock distribution amplifier

페이지 인쇄

OUTPUTS

AES/EBU XLR Outputs 1 through 4, 5 through 8, 9 through 12 and 13 through 16 operate as

independent groups. Also, BNC Outputs 1 through 6 operates as a group. Each or any of these

groups may be driven from the following input sources, as selected via rear panel DIP switches:

1. INPUT 1 AES/EBU

2. INPUT 2 AES/EBU

3. INPUT 3 AES/EBU

4. INPUT 4 AES/EBU

5. AES External Sync Input

6. Word Clock Input

7. AES 1 Frame Clock

It is not necessary to terminate unused outputs, as each is individually isolated. Cable routing

should be kept clear of AC lines and other noise-producing wiring.

FRONT PANEL DISPLAYS AND SWITCHES

POWER

Indicates power is supplied to the DDA and it is turned on.

INPUT FAULT

Indicates a no carrier condition on any of the six inputs, INPUT 1 (AES 1), INPUT 2 (AES 2),

INPUT3 (AES 3), INPUT4 (AES 4), AES SYNC IN (AES Sync) or WORD CLOCK INPUT (WCLK).

INPUT TERM

Indicates whether the input termination is on or off for the source selected by the Source Monitor &

Control switch. Press the INPUT TERM button to toggle the setting. Settings are individual for each

source selected, and are memorized and retained through power outages.

INPUT SAMPLE RATE

Indicates sample rate of the input selected by the Source Monitor & Control switch. Sample rates

from 32 kHz through 192 kHz are displayed when they are within 3% of nominal.

WORD LENGTH

Indicates the Word Length of the selected input signal from 16 through 24 bit.

DDA-‐416/WC106 M anual