Carmanah EG320 사용자 설명서 - 페이지 8

{카테고리_이름} Carmanah EG320에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah EG320 13 페이지. Eg-series
Carmanah EG320에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Testing the system

The EG320/EG340 Programmer can be used to test

the EG320/EG340 system. To test the system:

• Point the programmer at the IR transmitter/receiver

on the EG320/EG340 EMS.

• Press and hold the Test button on the programmer

until it beeps once.

• The LED fixture should turn on briefly to indicate

that the system is operating properly.

The test command may not be received by the

EG320/EG340 EMS on bright, sunny days. Try

getting closer to the EMS, or try testing later in the

day when the sunlight won't interfere as much with

communications. See the Troubleshooting section if

the fixture still will not turn on.

EMS Indicator Lights

The EG320/EG340 EMS has three indicator lights

which are visible from the ground at night. On bright

days, the lights may be difficult to see from the

ground, and a pair of binoculars can be used to see

the lights (do not look at the sun directly when operat-

ing binoculars).

The following table summarizes the behaviour of the

three EMS indicator lights:

Light symbol

Status

On (green)

Flashing (green)

Off

On (red)

Flashing (red)

Off

On (red)

DIM

Off

All 3 lights

Pulsing (all lights) Programming

EG320/EG340 USER MANUAL

tEStiNG thE SyStEM

Function

Not charging

(night detected)

Charging (day

detected)

No battery

connected

Load low/high

voltage discon-

nect (Load LVD/

HVD)

Load over-current

Load OK

Dimming due to

battery low/high

voltage discon-

nect (Battery

LVD/HVD)

Time-controlled

dimming