Carmanah R820-G 매뉴얼 - 페이지 6

{카테고리_이름} Carmanah R820-G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah R820-G 10 페이지. Cabinet-based systems
Carmanah R820-G에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (11 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 캐비닛 도어 교체 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 설치 매뉴얼 (14 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)

3.1

Door Switch Kit Mounting Holes

Ensure the equipment is not powered during installation.

Ensure all metal chips are removed to prevent system damage caused by short circuits.

Recheck all wiring prior to energizing the system.

If you do not see the indentation marks below on the side of the cabinet you have an older G

Series/SpeedCheck cabinet. Contact Carmanah for location guidance. Some legacy cabinets

may not be suitable for this installation.

1. Access the inside of the cabinet and remove the solar and battery fuses or turn off the circuit breaker.

2. Use the indentation marks below to locate the drill holes.

3. Drill two 0.196" diameter holes as noted using a #9 ANSI drill bit.

4. Deburr the holes on the outside and inside to remove all aluminum chips.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

CABINET DOOR SWITCH RETROFIT GUIDE

carmanah.com