Carmanah R820-G 매뉴얼 - 페이지 7

{카테고리_이름} Carmanah R820-G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah R820-G 10 페이지. Cabinet-based systems
Carmanah R820-G에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (11 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 캐비닛 도어 교체 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 설치 매뉴얼 (14 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지)

3.2

Installing Door Switch Kit

1. Apply Loctite 220 threadlocker to two standoffs.

2. Assemble standoffs to the inside of the cabinet using two security screws and two flat washers.

3. Fasten the long wire from door switch to slots with two cable ties. Leave loose/untrimmed for now.

4. Install door switch to the standoffs using two screws, two lock washers, and two flat washers.

5. Center switch front/rear in slots and tighten. No Loctite threadlocker is required for this step.

3.3

The terminal on the end of the long door switch wire gets installed into he Applied Information (AI)

harness connector in a later step.

1. Install ring terminal from door switch onto top Battery/DC Power RD + fuse holder terminal.

2. Install two cable tie bases as shown below. Fasten the long wire from door switch to the two cable tie

bases. Leave loose/untrimmed for now.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

CABINET DOOR SWITCH RETROFIT GUIDE

carmanah.com