Carmanah E Series 설치 매뉴얼 - 페이지 7

{카테고리_이름} Carmanah E Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah E Series 16 페이지. Rrfb mast arm kit
Carmanah E Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 설치 매뉴얼 (20 페이지), 사용자 설명서 (18 페이지), 교체 매뉴얼 (9 페이지), 설치 매뉴얼 (18 페이지)

4.0 E/F Series Solar Engine Installation

If the AI Integration Kit was order with a Carmanah E/F Series system, skip to

Instructions for installation reflect the F Series engine but are suitable for E Series as well.

4.1

1. Remove power to the system by disconnecting both battery fuse holders.

2. Obtain the AI 16-pin harness. Cut and remove terminal of the five wires shown (violet, blue, black, red,

and yellow). Leave the green wire ring terminal intact (not shown).

3. Cut yellow wire to same length as black wire. Cut a three-inch section of yellow wire and strip each end

0.35" for later use.

4. Install provided heat-shrink tubing around the five wires 4.25" from the end of black wire. Other wires will

end up being longer. Use heat gun to affix the heat-shrink tubing.

5. Strip insulation of the five wires 0.35".

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

INSTALL GUIDE

Section

4.4.

carmanah.com