Carmanah E Series Kurulum Kılavuzu - Sayfa 7

Güvenlik Sistemi Carmanah E Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Carmanah E Series 16 sayfaları. Rrfb mast arm kit
Ayrıca Carmanah E Series için: Hızlı Başlangıç Kılavuzu (20 sayfalar), Enerji Yönetim Sistemi Değiştirme Kılavuzu (12 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kullanıcı Kılavuzu (18 sayfalar), Değiştirme Kılavuzu (9 sayfalar), Kurulum Kılavuzu (18 sayfalar)

4.0 E/F Series Solar Engine Installation

If the AI Integration Kit was order with a Carmanah E/F Series system, skip to

Instructions for installation reflect the F Series engine but are suitable for E Series as well.

4.1

1. Remove power to the system by disconnecting both battery fuse holders.

2. Obtain the AI 16-pin harness. Cut and remove terminal of the five wires shown (violet, blue, black, red,

and yellow). Leave the green wire ring terminal intact (not shown).

3. Cut yellow wire to same length as black wire. Cut a three-inch section of yellow wire and strip each end

0.35" for later use.

4. Install provided heat-shrink tubing around the five wires 4.25" from the end of black wire. Other wires will

end up being longer. Use heat gun to affix the heat-shrink tubing.

5. Strip insulation of the five wires 0.35".

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

INSTALL GUIDE

Section

4.4.

carmanah.com