FORMTEK Lockformer CHEEK BENDER 매뉴얼
{카테고리_이름} FORMTEK Lockformer CHEEK BENDER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FORMTEK Lockformer CHEEK BENDER 3 페이지. Double sided 24” model
페이지 인쇄Page 1
OPERATION
Place the edge to be formed into the slot and move the handle to make a bend.
Ver. US-03-2005
711 Ogden Ave. Lisle, IL, 60532, USA
tel# 1-630-964-8000,
WWW.LOCKFORMER.COM
CHEEK BENDER
Double sided 24" Model
Instructions
MOUNTING UNIT
Place the cheek bender on
work table so that sufficient
clearance is available for
bending the maximum size
section. Make sure that the
unit is placed so the open end
over hangs the table. When
the unit is in the most desired
work position, fasten it to a
work table or bench.
Place handles into the pivot
bar holes and lock them into
place with Allen head screws.