FORMTEK Lockformer CHEEK BENDER 매뉴얼 - 페이지 2
{카테고리_이름} FORMTEK Lockformer CHEEK BENDER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FORMTEK Lockformer CHEEK BENDER 3 페이지. Double sided 24” model
페이지 인쇄Page 2
TO CHANGE FLANGE HEIGHT
The shims are set at the factory to run a flange of ¼" (6mm). This dimension can be
changed in the following manner. Remove the 4 Hex. Hd cap screws on the plate and
change the desired dimension. The adjustable shim will give a range of ¼" (6mm) to 7/8"
(22mm). This procedure can be done on the left and right plates if desired.
PARTS FOR 24" double sided CHEEK BENDER
• Pictures are not to scale!
•
Handle # 4R151
2G208 Bottom Plate
#
# 25095 Pivot Bar Right
Ver. US-03-2005
711 Ogden Ave. Lisle, IL, 60532, USA
tel# 1-630-964-8000,
WWW.LOCKFORMER.COM
Grip # 5T667
Trunion Plate # 3D310
#250965 Pivot Bar Left