Carmanah G Series 사용자 설명서 - 페이지 12

{카테고리_이름} Carmanah G Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah G Series 18 페이지. Rrfb mast arm kit
Carmanah G Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (11 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 캐비닛 도어 교체 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 설치 매뉴얼 (14 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 설치 매뉴얼 (18 페이지)

6.1

Connecting to the Radar Module

1. Remove the dust cap from the DB9 connector within the Carmanah E, F or G system.

2. Plug the USB-to-Serial adapter into the DB9 connector within the Carmanah E, F or G system.

3. Plug one end of the USB extension into the USB-to-Serial adapter, and the other end into the USB port of

the PC.

4. Start the Advanced Stats Analyzer program.

5. Select the "Connect to Radar" option from the top banner.

6. Click the "Connect to Radar" button. (Software scans ports until radar found.)

7. Ensure you see a "Radar Found on..." message.

8. Click "OK".

The radar module is powered by the Carmanah E, F or G system to which it is connected. To be

configured using the programming kit, the radar module must be connected to an operating

Carmanah E, F or G system.

More information about radar module settings can be found in the Houston Radar DR600 User

Manual, available at https://www.houston-radar.com. To avoid unintended operation and/or

excessive power consumption, configuration changes should be limited to those discussed in this

section. Other settings should be left at their default values.

Adjusting settings not outlined in this section may adversely affect radar detection performance.

Contact Carmanah for assistance with any configuration settings not discussed in this manual.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

RADAR DETECTION KIT

carmanah.com