Andatech AlcoSense AccessPoint 사용자 설명서 - 페이지 6

{카테고리_이름} Andatech AlcoSense AccessPoint에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andatech AlcoSense AccessPoint 12 페이지. Breathalyser

How to Use

1. Open the sampling hole cover of the AlcoSense AccessPoint

2. Make sure the STATUS light is green

3. Blow into the sampling hole

4. Depending on the test results, Pass or Fail lamp will blink

* If breath sample is not strong enough for an analysis, the STATUS light will turn red.

How to Set Buzzer, Autopower & Pass Level

sw①

sw②

sw③

1. Switch off and open the device

2. Press "SW1" and "SW2" at the same time, hold them down four seconds and then release them. FND display will

turn on and " bUZ" will be displayed.

3. If you push " SW1" , you can see 3 kinds of setting modes.

1) bUZ: Set the buzzer on or off

2) Fr E: Auto power ON (Fon) / OFF (Fof)

3) Lo: Set the PASS level

4. Set the Functions

1) Buzzer on/off

Press " SW2" until you can see " bUZ" on display.

Y ou will see "bon" . If you press " SW2" again you will see " bof" .

" bon" means buzzer on and " bof" means buzzer off.

2) Auto power on/off

Press " SW2" until you can see " FrE" on display.

Version Number

Date Updated

V1.1

2.12.2015