Andatech AlcoSense AccessPoint User Manual - Page 6

Browse online or download pdf User Manual for Test Equipment Andatech AlcoSense AccessPoint. Andatech AlcoSense AccessPoint 12 pages. Breathalyser

Print Page

How to Use

1. Open the sampling hole cover of the AlcoSense AccessPoint

2. Make sure the STATUS light is green

3. Blow into the sampling hole

4. Depending on the test results, Pass or Fail lamp will blink

* If breath sample is not strong enough for an analysis, the STATUS light will turn red.

How to Set Buzzer, Autopower & Pass Level

sw①

sw②

sw③

1. Switch off and open the device

2. Press "SW1" and "SW2" at the same time, hold them down four seconds and then release them. FND display will

turn on and " bUZ" will be displayed.

3. If you push " SW1" , you can see 3 kinds of setting modes.

1) bUZ: Set the buzzer on or off

2) Fr E: Auto power ON (Fon) / OFF (Fof)

3) Lo: Set the PASS level

4. Set the Functions

1) Buzzer on/off

Press " SW2" until you can see " bUZ" on display.

Y ou will see "bon" . If you press " SW2" again you will see " bof" .

" bon" means buzzer on and " bof" means buzzer off.

2) Auto power on/off

Press " SW2" until you can see " FrE" on display.

Version Number

Date Updated

V1.1

2.12.2015