Carmanah F Series 교체 매뉴얼 - 페이지 6
{카테고리_이름} Carmanah F Series에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah F Series 9 페이지. Rrfb mast arm kit
Carmanah F Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지), 에너지 관리 시스템 교체 매뉴얼 (12 페이지), 설치 매뉴얼 (20 페이지), 사용자 설명서 (18 페이지), 설치 매뉴얼 (18 페이지)
3.0 Installation Procedure
This guide is for installing a replacement solar panel into one of the following compatible Carmanah systems:
•
Legacy – R920, R247-E
•
E Series – R920-E, R820-E, R247-E, R829-E
•
F Series – R920-F, R820-F, R247-F, R829-F
The images in this guide focus on E Series (or legacy R920/R247-E) systems. The same steps are used for F
Series systems.
3.1
Disconnect Existing Wiring
1. Remove power to the system by disconnecting both battery fuses.
2. Cut the cable ties holding the solar panel cable. Remove the four screws on the Energy Management
System (EMS) enclosure to gain access to the circuit board connection. Remove the cable tie holding the
solar panel cable in place inside the EMS enclosure. Remove the solar panel wires from the circuit board
terminals by pressing down on the release buttons and pulling out the wires. Cap off or tape the wires
temporarily as voltage may be present.
3. For the legacy R247-E or R920 systems only, refer to
you have. For horizontal opening engines you will need to modify the replacement solar panel as in
Section
3.2. Otherwise proceed to
Remove
Cut cable tie
Cut cable tie
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
SOLAR PANEL REPLACEMENT GUIDE
Section 2.1
Section
3.3.
to see which version of solar engine
Remove
|
carmanah.com
6