Carmanah F Series Instrukcja wymiany - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Panel słoneczny Carmanah F Series. Carmanah F Series 9 stron. Rrfb mast arm kit
Również dla Carmanah F Series: Skrócona instrukcja obsługi (20 strony), Instrukcja instalacji (20 strony), Instrukcja instalacji (16 strony), Podręcznik wymiany systemu zarządzania energią (12 strony), Instrukcja instalacji (20 strony), Podręcznik użytkownika (18 strony), Instrukcja instalacji (18 strony)

3.0 Installation Procedure

This guide is for installing a replacement solar panel into one of the following compatible Carmanah systems:

•

Legacy – R920, R247-E

•

E Series – R920-E, R820-E, R247-E, R829-E

•

F Series – R920-F, R820-F, R247-F, R829-F

The images in this guide focus on E Series (or legacy R920/R247-E) systems. The same steps are used for F

Series systems.

3.1

1. Remove power to the system by disconnecting both battery fuses.

2. Cut the cable ties holding the solar panel cable. Remove the four screws on the Energy Management

System (EMS) enclosure to gain access to the circuit board connection. Remove the cable tie holding the

solar panel cable in place inside the EMS enclosure. Remove the solar panel wires from the circuit board

terminals by pressing down on the release buttons and pulling out the wires. Cap off or tape the wires

temporarily as voltage may be present.

3. For the legacy R247-E or R920 systems only, refer to

you have. For horizontal opening engines you will need to modify the replacement solar panel as in

Section

3.2. Otherwise proceed to

Remove

Cut cable tie

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

SOLAR PANEL REPLACEMENT GUIDE

Section 2.1

Section

3.3.

to see which version of solar engine

Remove

carmanah.com