Andatech ASC-200 사용자 설명서 - 페이지 9

{카테고리_이름} Andatech ASC-200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andatech ASC-200 17 페이지. Smart wireless solar camera

Installation Instructions

The SolarCam can be mounted onto a post or on a wall. The wall must be

thick enough to hold three times the weight of the camera.

1) Prior to setup and selecting the location of installation:

a. Confirm that there will be stable WiFi signal (at least two grids of

signals). If the signal is not strong enough, you may need to install a

WiFi booster or repeater to extend the WiFi coverage.

b. Select an area with sufficient sunlight. Ideally, position the camera

under direct sunlight.

c. Avoid areas with moving objects that may interfere with the camera.

2) Wall Mount Setup

a. Remove the sticker and place it onto the wall where you wish to

set up the camera.

b. Drill holes in the 3 marked circles and insert the green expansion

screw into the hole. (See Fig. 2.2)

Repeater

Camera

c . Align the holes of the mounting bracket with the expansion screws

and secure the bracket into place. (See Fig. 2.3)

d. Install the camera onto the bracket and secure it in place using the

screw.

3) Post Mount Setup

a. Secure the mounting bracket onto the post or pole with the plastic

zip ties provided and tighten them as much as possible. (See Fig.2.4)

b. Install the camera onto the bracket and secure it in place using the

screw.

Router

Fig. 2.1

Fig. 2.2