Carmanah SPEEDCHECK 교체 매뉴얼 - 페이지 7

{카테고리_이름} Carmanah SPEEDCHECK에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Carmanah SPEEDCHECK 10 페이지. For the solar-powered speedcheck-15/18 radar speed signs
Carmanah SPEEDCHECK에 대해서도 마찬가지입니다: 교체 매뉴얼 (11 페이지), 교체 매뉴얼 (10 페이지)

페이지 인쇄

3.2

SPEEDCHECK-15/18

1. Disconnect power to the SPEEDCHECK-15/18 sign by removing the fuse(s) in the associated battery

cabinet.

2. Disconnect the wiring and remove the existing charge controller from the battery cabinet. Remove the

solar panel wires last and cap off temporarily with wire nuts.

3. For systems that are replacing the legacy ASC charge controller you will require the retrofit mounting

bracket. Attach the new charge controller using the provided mounting screws to the battery box. All six

screws are required when replacing the ASC charge controller.

4. Refer to

Section 3.1

Radar sign power

cable to Load +/-

a. Ensure the radar sign power cable is connected to the load terminals. This will enable the sign to

take advantage of the charge controller's built-in low voltage disconnection protection.

b. Keep track of the polarity for each component (red/yellow = positive, black/brown = negative).

5. Refer to

Section 4.0

removed, otherwise the charge controller may exhibit a load error.

6. Reinstall the fuses in the battery cabinet to apply power to the radar sign. Ensure the charge controller

charging status LED turns green and the battery starts charging.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

and below for wiring the new charge controller, using the same existing wiring.

Without StreetHub Option

to confirm if your system has a large capacitor installed. If this is present it must be

SOLAR CHARGE CONTROLLER

REPLACEMENT GUIDE

With StreetHub Option

[email protected]

Radar sign power

cable to DC+/-

carmanah.com